Πώς να Φτιάξετε Ισορροπημένη Κινητική Γλυπτική (Balanced Kinetic Sculpture)
Εισαγωγή
Balanced kinetic sculpture = artwork με κίνηση + ισορροπία σε ενικό σημείο. Κίνηση: αέρας, ηλεκτρονικά, αγγίγματα. Mobile = παράδειγμα (κρεμάται από πάνω). Απαραίτητο: planning + patience.
Απαραίτητα Υλικά
- Τρύπανο
- Wood block
- 18 gauge copper wire
- Wire cutters
- Needle nose pliers
- Wood putty
- Μπερδέ, κουμπιά
Οδηγίες
Wooden Base
- Micro τρύπα κέντρο wood block. Micro bit για 18-gauge wire.
- Κόψτε 7-8 inch copper wire.
- Shepherd's hook shape: χέρια + pliers. Ένα κάτω bend (μακρύ/κλιμακωτό). Τέλος: upward hook.
- Straight section -> wood block hole.
- Wood putty για στερέωση. Dry.
- Κόψτε 12-inch copper wire.
- Bend σε δύο.
- Edges opposite -> small loop κέντρο. Pliers shape. Test balance: δαγκώνω με pliers. Αν όχι balanced -> restart loop.
- Bend long wire σε shapes αριστερά/δεξιά (creative: curves, spirals).
- Beads/buttons στο long wire. Ισόβαρη κάθε πλευρά.
- Bend ends -> decorations not slide off.
- Hang long wire από hook short wire. Loop -> hook -> balance.
Mobile
- Τρία 7-inch copper wires.
- Layout mobile shape. Wires slightly offset (π.χ. stair step design).
- Decorations κάτω piece πρώτα (butterflies, buttons). Weight minimal.
- Center of balance -> fishing line position.
- Fishing line -> end of wire πάνω. Pliers bend -> no slip.
- Decorations opposite end -> balance. Weight > section κάτω.
- Balance point 2η section -> fishing line.
- Επανάληψη steps 5-7 για final section. Mobile balanced all levels, freely floats.