Πώς να Δημιουργήσετε Metal Casting Molds (Μεταλλικά Μόλντ)
Εισαγωγή
Metal-casting = παλαιότερη metallurgical art. Μέταλλο -> molten -> molds για ingots ή finished art. Mold creation = most creative aspect. Concave για ingots, convex για 3D objects/sculptures. Lost wax technique με liquid rubber + ceramic silica sand.
Απαραίτητα Υλικά
- Metallic model να αναπαραγαγοποιηθεί
- Spray-on polyurethane rubber release agent
- Liquid polyurethane rubber molding material
- Paintbrush
- Casting wax
- Coat hanger
- Paint thinner
- 5-gallon plastic bucket
- Power drill
- Air compressor
- Ceramic silica sand
- Plastic bucket
- Liquid silicone adhesive
Οδηγίες
- Spray release agent: Model/sculpture. Dry 몇 hours.
- 3 coats liquid rubber: Brush, 4 hours dry μεταξύ coats. Intermediate rubber mold για wax model.
- Peel rubber mold: Μικρά areas (χέρια/δάχτυλα) -> massage/twist. Inside out -> paint thinner + rag για release material.
- Support mold: Ραγκάς. Melt casting wax -> fill mold. Wire/coat hanger -> holding wire. Cool 8 hours.
- Sand-casting bucket: 5-gallon bucket: 1-inch hole 2 inches above base. Air compressor nozzle -> hole -> bottom. 3 inches ceramic silica sand. Heavy rag cover.
- Remove rubber από wax: Liquid silicone adhesive -> small bucket. Wax model by wire -> dip adhesive (ΟΧΙ flat bottom). Drip 30 sec.
- Air compressor ON: Rag back. Bubbling sand swirling upper bucket. Insert adhesive-covered wax model. Pull rag over hand -> sand attaches σε wet adhesive.
- Hold 3 minutes: Remove, hang dry 1 hour. Repeat x19 = 1/2 inch thick silica/silicone mold.
- Burn out wax: Pull wire. Coat hanger frame -> mold upside down. Small metal pan -> oven 450°F 2 hours. Wax melts/runs out. Result: concave silica mold για molten metal (brass, copper, aluminum, pewter) -> near-perfect reproduction.